- OvmsDev - Open Vehicles

v2.2.5
by Mark Webb-Johnson 16 Apr '13

16 Apr '13

Back from the brink… Good grief, there is some nasty stuff coming out of China now. I managed to spend some time on OVMS firmware today, and built v2.2.5. Change log is: 2013-04-01 2.2.5 Firmware 2.2.5 ### Fixes for charge notification logic on VA ### Show charge, trunk and alarm notifications in DIAG mode ### Speed, parking, and general tidy-ups for VA ### Switch ambient temperature to PID 0x801f for VA ### Auto-calibration for 12V line reading ### Twizy version 2.6.1 - power line plug-in detection ### Add car_doors5 for rear doors, frunk and 12v charging ### 12v alert by MSG protocol fix ### Rework of 12V reference logic - Filters out single peaks / misreadings - Sends "OK" alerts if voltage level restores w/o charging - 15 minutes calmdown before taking new ref voltage - No alerts while car is on ### ESS SOC DIAG (for TR) ### Initial support for CAC in TR and TZ modules ### Experimental Tazzari (TZ) module ### Experimental Nissan Leaf (NL) module All is in github. I haven't run it in my car yet, but it tests out fine on the bench. It is going into my car in a few minutes time. Major changes are the experimental support for Tazzari, some bug fixes and 12V work on Twizzy, and support for CAC readings in Tazzari and Tesla Roadster (including protocol extensions to report back to apps). Regards, Mark. P.S. I haven't had time to make anything good for 1st April this year (although I did consider an experimental module for Hummer support). Anyway, please consider any bugs in this version just an April fools joke.

6 39

Re: [Ovmsdev] WG: Release Firmware
by Mark Webb-Johnson 16 Apr '13

16 Apr '13

Pierre, To get CAC you need to either (a) turn car on, (b) turn car off, or (c) start a charge. It should then show up in the output. I checked the server logs, and it is now showing up for your car, so that should be ok in STAT SMS now. Regards, Mark. On 16 Apr, 2013, at 4:26 AM, Pierre Uhl wrote: > > Good morning Mark, > > Flashed my Tesla and everything is working except CAC. > > I got another Error for your collection: ID 1084 DMC FW:HCS Faulted warning. > It is possible that this is because too much humidity in the HPC-Box. > > Regards > > Pierre > > > > <Screenshot_2013-04-15-21-16-53.png><Screenshot_2013-04-15-21-17-19.png><20130410_123601a.jpg>_______________________________________________ > OvmsDev mailing list > OvmsDev(a)lists.teslaclub.hk > http://lists.teslaclub.hk/mailman/listinfo/ovmsdev

1 0

Re: [Ovmsdev] WG: Release Firmware
by Pierre Uhl 16 Apr '13

16 Apr '13

Screenshot_2013-04-15-23-10-47.png OOD was more than 60000 km before, now 38234.0 km Pierre -----Ursprüngliche Nachricht----- Von: ovmsdev-bounces(a)lists.teslaclub.hk [mailto:ovmsdev-bounces@lists.teslaclub.hk] Im Auftrag von Pierre Uhl Gesendet: Montag, 15. April 2013 22:26 An: ovmsdev(a)lists.teslaclub.hk Betreff: [Ovmsdev] WG: Release Firmware Good morning Mark, Flashed my Tesla and everything is working except CAC. I got another Error for your collection: ID 1084 DMC FW:HCS Faulted warning. It is possible that this is because too much humidity in the HPC-Box. Regards Pierre

1 0

WG: Release Firmware
by Pierre Uhl 16 Apr '13

16 Apr '13

Good morning Mark, Flashed my Tesla and everything is working except CAC. I got another Error for your collection: ID 1084 DMC FW:HCS Faulted warning. It is possible that this is because too much humidity in the HPC-Box. Regards Pierre

1 0

Broken Hardware
by Patrick Kapsch 15 Apr '13

15 Apr '13

I guess one of my three OVMS modules is broken. It keeps giving me 2x blink for "Can't communicate with modem" followed by a Modem reset and a new boot process. Any advice? Patrick

2 3

Comments on Tazzari Firmware
by Patrick Kapsch 14 Apr '13

14 Apr '13

Mark, Since you fixed push notifications, fully charged notification works for the Tazzari. Charge interrupt notification doesn't. Regards, Patrick

2 2

Got pebbles
by Mark Webb-Johnson 13 Apr '13

13 Apr '13

Wrist notifications.

3 6

Re: [Ovmsdev] v2.2.5
by Mark Webb-Johnson 11 Apr '13

11 Apr '13

Urgh, what is it with these little 12v batteries in EVs? There must be a better way. I've now heard of these problems in Nissan Leafs, Tesla Roadsters, Twizzies, Volt/Amperas, and Tesla Model S's. Hope it gets fixed quickly for you. Regards, Mark. > Hi, > > not in the Moment. Car is in the repair shop. Electronic and/or 12V Batterie Problem. > A few days ago the car was dead. 12Volt Line shows 5.5V. > > Bye > Michael J. > > Am 02.04.2013 um 14:55 schrieb Mark Webb-Johnson <mark at webb-johnson.net>: > > >> > >> On the Ampera there is no more temperature and no more charging indicator. > > > > Urgh. Michael: Can you test this and see if anything was broken?

3 4

Re: [Ovmsdev] Tazzari Pictures for the App
by Mark Webb-Johnson 11 Apr '13

11 Apr '13

Patrick, Image was too big for the list, but I grabbed it ok. If anyone wants it, just let me know (it is about 10MB). That is fine, and good to work from for the main picture. I'll have a look around for the top down pictures. Regards, Mark. > From: Patrick Kapsch <patrick.kapsch(a)mac.com> > Subject: Re: [Ovmsdev] Tazzari Pictures for the App > Date: 10 April, 2013 8:17:27 PM GMT+08:00 > To: OVMS Developers <ovmsdev(a)lists.teslaclub.hk> > > > Hi all, > I've managed to get my hands on a high-res PSD-File of a Tazzari Zero. I'm afraid there is no picture from the top. > > In this video one can see the car from the top multiple times from various angles. > > http://www.youtube.com/watch?v=CmXEXnYnntY > > Maybe someone is talented enough to outline the rough edges of the car to a near-perfect x-ray-view from above. > > Patrick

1 0

Tazzari Pictures for the App
by Patrick Kapsch 09 Apr '13

09 Apr '13

Hi Guys, attached you find a picture which could be used to integrate the Tazzari Zero into the range of cars in the App. It isn't anywhere near high-res but a decent size which is usable for now. Regards, Patrick

4 17