On 07/26/2014 08:22 AM, ovmsdev-request@lists.teslaclub.hk wrote:
Message: 2 Date: Sat, 26 Jul 2014 09:30:47 +0200 From: Michael Balzer <dexter@expeedo.de> Subject: Re: [Ovmsdev] OVMS v2 startup weirdness To: ovmsdev@lists.teslaclub.hk Message-ID: <53D35927.5040304@expeedo.de> Content-Type: text/plain; charset="iso-8859-1"; Format="flowed"
Hi Jeff,
there's a really good trouble shooting guide on the OVMS website:
http://www.openvehicles.com/helpme
Also, serial port params are 9600 8N1, no handshake -- see OVMS development PDF for more.
Regards, Michael
Am 26.07.2014 08:39, schrieb Aatheus:
Hi all
I just got my OVMS v2 module, with GeoSIM. I registered the SIM online, then tried to putting it into the OVMS SIM socket. I provisioned the module via the SMS provisioning page (using the +44 number). However, the board seems to be looping while trying to start up.
The board blinks its version OK (2.6.5), then starts trying to connect. I see 10 green blinks for a few iterations. Then the board blinks 6 green for about a minute. Then both lights come on solid for about 15-20 seconds. Then a pause, then six blinks. Repeat until the end of time. This 6 blinks for a minute, solid on for 15-20 seconds, then 6 blinks loop never ends.
What could be going on? I tried connecting to the diag port via serial (115k 8n1 none) and am getting nothing. I tried with hardware flow control on as well. Still nothing. I tried reflashing the board via PICkit2 and redoing the provisioning. Still no good.
Thanks! -Jeff
OvmsDev mailing list OvmsDev@lists.teslaclub.hk http://lists.teslaclub.hk/mailman/listinfo/ovmsdev
Mark,
Thank you for the info. Can the serial port parameters get added to the helpme page? The info is not findable anywhere on the page. I did find it in the development PDF, but it was hard to find!
I managed to get serial access to the OVMS board, and it looks like the data call is repeatedly failing. I verified that my GeoSIM card has $15 balance on it. Is my SIM card screwed up? I activated the SIM on the GeoSIM site, and I think it's set up ok.
RDY
+CFUN: 1
+CPIN: READY
+PACSP: 1
+CREG: 0
+CREG: 2
Call Ready
GPS Ready AT
OK AT+CGPSPWR=1;+CGPSRST=0;+CSMINS?
+CSMINS: 0,1
OK AT+CCID;+CPBF="O-";+CPIN?
(SERIAL OBSCURED)
+CPIN: READY
OK AT+IPR?;+CREG=1;+CLIP=1;+CMGF=1;+CNMI=2,2;+CSDH=1;+CIPSPRT=0;+CIPQSEND=1;+CLTS=1;E0
+IPR: 9600
OK
ERROR
+CREG: 3
+CREG: 0
OK
+CSMINS: 0,1
OK
(SERIAL OBSCURED) +CPIN: READY
OK
+IPR: 9600
OK
ERROR
+CREG: 3
OK
+CSMINS: 0,1
OK
(SERIAL OBSCURED)
+CPIN: READY
OK
+IPR: 9600
OK
ERROR