Hi, Found an issue in the mcp2515 driver while working on the e-Golf module. SetAcceptanceFilter() writes the filter and mask registers correctly but never switches RXMODE from 3 (receive all) to 0 (filter-matched), so the hardware filters are never actually active. Looks like it was never exercised in any vehicle module, NIU GTevo has the call commented out. Also, REG_RXB1CTRL is missing from the regdefs. This matters on the e-Golf because without the filter the OBC floods FCAN at ~860 frames/s during charging, which starves the Events task and triggers TWDT resets. The filter drops it to the 5 IDs we actually decode, which fixes it. Fix I have: SetAcceptanceFilter() clears RXMODE to 0 on both RX buffers after writing the registers, and stores the config so Start() can re-apply it on SetPowerMode(On), otherwise every ignition cycle resets RXMODE back to 3. Tested on hardware, working fine. Happy to send a PR if the approach looks right. Andreas