Got mine as well, without customs hassle. My dust caps were in place and OK. The top shell also is a bit wider than the bottom, but nowhere near 1 mm, more like 0.2 - 0.3. Regards, Michael Am 14.04.2018 um 00:49 schrieb Greg D.:
Hi Mark,
The 3.1 module arrived in today's mail. I haven't plugged it in yet, but two "unboxing" observations...
The unit looks really nice, though it seems that the top shell is a tad too wide and overlaps the bottom piece by nearly a mm on one corner. And, not evenly, at that; it's like the corner by the Vehicle connector got stretched a bit outward (or the other half pushed inward). The other two sides are all pretty evenly matched. The 3.0 proto unit was not like this. {shrug}
Also, the two SMA dust caps seemed to have had some reaction with the adhesive on the flap of the padded envelope. They were stuck to the flap, pulled away from the connectors (so, not much dust protection), and the adhesive on the flap seemed to be very gooey in that area. The caps seemed to have been more or less unaffected, so it's more of a cosmetic issue. Perhaps they could point the module in the other direction (SMA end first), to prevent this in the future?
My intent is to play "customer" with this unit, only using officially released code, updated through typical methods (i.e. not via the developer's kit) unless I need to do otherwise. I've got some short-term distractions through the weekend, but will take it out for a spin next week.
Greg
_______________________________________________ OvmsDev mailing list OvmsDev@lists.openvehicles.com http://lists.openvehicles.com/mailman/listinfo/ovmsdev
-- Michael Balzer * Helkenberger Weg 9 * D-58256 Ennepetal Fon 02333 / 833 5735 * Handy 0176 / 206 989 26