SDCARD factoryreset.txt Hold the program button down for several seconds Command-line Maybe not a factory reset but a corrupt config partition? Can you try to change config. Then reboot. Then check config is still there? Regards, Mark.
On 20 Jun 2018, at 3:56 PM, Stephen Casner <casner@acm.org> wrote:
This evening I connected my new OVMS v3.1 to my laptop and went through the setup wizard. That seemed to go smoothly. I copied over my ssh key and things seemed to be working fine. I installed an SD card so I could do logging if needed, and then unplugged the module to install it in the car. But it didn't come up!
After I brought it back to the desk and connected to the laptop again, I see a message on the console that it has factory reset itself.
What are the ways to trigger a factory reset? I must have unintentionally hit one.
-- Steve _______________________________________________ OvmsDev mailing list OvmsDev@lists.openvehicles.com http://lists.openvehicles.com/mailman/listinfo/ovmsdev