26 May
2020
26 May
'20
10:27 a.m.
Craig, Yes, if your board is more than a year or so old, you can hand modify with a simple jumper between the DA26 and DB9. Regards, Mark.
On 24 May 2020, at 8:06 AM, Craig Leres <leres@xse.com> wrote:
On 2020-05-23 15:18, Craig Leres wrote:
I think I could still feed the J1850 bus on pin 1 of the DB9.
I see now that pin 1 of DB9 is open on a V3.1 module (as is shown in the V3.1 schematic). Is the correct update to run a jumper from pin 21 of DA26 to pin 1 of DB9?
Craig
_______________________________________________ OvmsDev mailing list OvmsDev@lists.openvehicles.com http://lists.openvehicles.com/mailman/listinfo/ovmsdev