Hi all, I know some of this (especially for the status) functionality is predicated on code that's not gone up yet - however this is allowing 'pause' and 'resume' of the poller (which has been merged). My question is not so much about the functionality and status information, but about the location of the *poller* subcommand. (See below). Should 'vehicle' be exclusively for switching the vehicle type? Should the 'poller' command be top-level? Under obdii? Thoughts welcome. If you do vehicle poller pause then the last line reads 'Vehicle OBD Polling is paused' //. -------8<---------------------------------------- *OVMS# vehicle ?* Usage: vehicle [list|module|poller|status] list Show list of available vehicle modules module Set (or clear) vehicle module poller OBD polling status status Show vehicle module status *OVMS# vehicle poller ?* Usage: vehicle poller [pause|resume] pause Pause OBD Polling resume Resume OBD Polling *OVMS# vehicle poller* OBD Polling running on bus 1 with an active list Time between polling ticks is 1000ms with 1 secondary sub-ticks Last poll command received 1s (ticks) ago. Vehicle OBD Polling is running.