Hi
Can you try to see if adding this code also works for you? >After "case 0x1db:" > // state of charge percentage, as shown on dash info panel > uint8_t soc = d[4] & 0x7f; > if(soc != 0x7f) > { > StandardMetrics.ms_v_bat_soc->SetValue(soc); > }
I tried the change you suggested. SOC is stable now. Nice! -Stein Arne Sordal- On 2018-05-02 15:55, Robin O'Leary <ovmsdev@caederus.org> wrote:
On Wed, May 02, 2018 at 03:43:33PM +0200, ovms wrote: > Tom, you are right. I used a standard cable, not a Leaf-specific cable. And the 0x50d is on the car-bus. > I have now swapped to a Leaf-specific cable, and tried to change the code to look for 0x50d on the car bus, but I apparently did something wrong. No data from the car-bus is received now. Can you try to see if adding this code also works for you? After "case 0x1db:" // state of charge percentage, as shown on dash info panel uint8_t soc = d[4] & 0x7f; if(soc != 0x7f) { StandardMetrics.ms_v_bat_soc->SetValue(soc); } _______________________________________________ OvmsDev mailing list OvmsDev@lists.openvehicles.com http://lists.openvehicles.com/mailman/listinfo/ovmsdev