Julien, Am 24.09.2014 um 16:30 schrieb Julien NOZAIS:
Nothing wrong with my build, I am in 2.6.6 and I can do CFG commands. I have played a bit with the SPEED command, keeping it simple for now. :) I freaked out a bit when the car started beeping as I wasn't (still am not) familiar with the power cycle thing.
Correct me if I'm wrong, I understood that doing a power cycle means starting the car by turning the key on the first notch, waiting 10-15 sec (I noticed a red led blinking on the board at that point), then turning it off and on again. Is it the standard way to do it ?
Power cycle means switching off and on again -- a reset would do as well if the Twizy had a reset button. To change some power map setup you normally turn the key to the first notch, issue the CFG command(s), turn off and then on as usual. First notch is necessary to allow for the SEVCON PRE-OP state. While in "GO" state, you can still change any config that doesn't need PRE-OP state. See manual for details, especially the section on the SimpleConsole and example profiles. PRE-OP state will sometimes stick (presumably due to some internal value checks), then you need to do a power cycle to resolve. Regards, Michael -- Michael Balzer * Paradestr. 8 * D-42107 Wuppertal Fon 0202 / 272 2201 * Handy 0176 / 206 989 26