Mark, My previous message was sent before I noticed that additional relevant commits were made today. After updating, I find that the looping still happens but "simcom setstate PoweredOff" stops the looping. At that point: OVMS# simcom status SIMCOM Network Registration: NotRegistered State: PoweredOff Ticker: 576 User Data: 0 Mux Status: down Open Channels: 0 Framing Errors: 0 Last RX frame: 0 sec(s) ago RX frames: 0 TX frames: 0 PPP Not Connected Last Error: Undefined GPS Status: disabled Time: disabled NMEA: GPS/GLONASS Not Connected OVMS# conf list auto auto (readable writeable) ext12v: no init: yes modem: no obd2ecu: server.v2: no server.v3: no vehicle.type: TR wifi.mode: client wifi.ssid.ap: OVMS wifi.ssid.client: Revelstoke OVMS# But "power simcom off" causes the looping to start again. -- Steve On Tue, 24 Apr 2018, Mark Webb-Johnson wrote:
Steven,
What does 'simcom status' show you? Also 'config list auto'? I'm looking for the boot-time auto, and current desired power on status for the simcom.
Can you try 'power simcom off'?
Regards, Mark.
On 24 Apr 2018, at 8:56 AM, Stephen Casner <casner@acm.org> wrote:
On Sun, 22 Apr 2018, Michael Balzer wrote:
The effect of (a) is the modem only answers "ERROR" to the +CGDATA="PPP" command. I have tried different commands to reset the internal state, but it was stuck, only a power cycle could solve this. I have added an automatic power cycle for this situation, but it didn't occur again yet.
My modem has been in the powered-off state for quite some time because I have only been testing on the bench where I have wifi connectivity. Today I installed the module in my Roadster to test some metrics as requested by Greg, and when I plugged it in I saw the blue modem light come on. After I did my test and removed the module to bring it back in and connect to my laptop, the blue light is still on. About every 20 seconds I see this cycle repeating:
I (43342) simcom: State timeout, transition to 1 I (43342) simcom: State: Enter CheckPowerOff state I (54352) simcom: State: Enter PoweringOff state I (54352) gsm-ppp: Shutdown (direct) I (54352) gsm-nmea: Shutdown (direct) I (54352) simcom: Power Cycle I (54352) netmanager: Interface priority is st1 (192.168.1.84/255.255.255.0 gateway 192.168.1.254)
A command "simcom setstate PoweredOff" is not effective.
-- Steve _______________________________________________ OvmsDev mailing list OvmsDev@lists.openvehicles.com http://lists.openvehicles.com/mailman/listinfo/ovmsdev
_______________________________________________ OvmsDev mailing list OvmsDev@lists.openvehicles.com http://lists.openvehicles.com/mailman/listinfo/ovmsdev