I think that this can control it (on SIM5360):

Disable:

simcom muxtx 3 AT+CGFUNC=1,0

Enable:

simcom muxtx 3 AT+CGFUNC=1,1

There is also AT+CLEDITST, but I can’t seem to make that work.

Black case should be darker and let light through. The 3D printed prototypes are very transparent.

Regards, Mark.

On 19 Dec 2017, at 3:37 PM, Michael Balzer <dexter@expeedo.de> wrote:

Greg,

the blue LED is not controllable, it's acting as a Zener diode in the voltage regulation, i.e. it flashes when draining a too high voltage.

So, as a workaround you could replace it by a standard Zener diode, just needs to have the same breakdown voltage.

But I don't think the black case lets through much light -- Mark?

Regards,
Michael


Am 19.12.2017 um 05:47 schrieb Greg D.:

Hi folks,

The "real" module's case is black, but how well does it block light?

I'm thinking about the modem's LED, which flashes pretty brightly in the
proto (white) case.  In a dark parking lot, it could attract unwanted
attention.  (Or, perhaps simulate a car alarm, which wouldn't
necessarily be bad...)

If the LED is visible externally, is there a way to disable it?

Greg



_______________________________________________
OvmsDev mailing list
OvmsDev@lists.teslaclub.hk
http://lists.teslaclub.hk/mailman/listinfo/ovmsdev

--
Michael Balzer * Helkenberger Weg 9 * D-58256 Ennepetal
Fon 02333 / 833 5735 * Handy 0176 / 206 989 26


_______________________________________________
OvmsDev mailing list
OvmsDev@lists.teslaclub.hk
http://lists.teslaclub.hk/mailman/listinfo/ovmsdev

_______________________________________________
OvmsDev mailing list
OvmsDev@lists.teslaclub.hk
http://lists.teslaclub.hk/mailman/listinfo/ovmsdev

-- 
Michael Balzer * Helkenberger Weg 9 * D-58256 Ennepetal
Fon 02333 / 833 5735 * Handy 0176 / 206 989 26