Hi Nikolay,

I've seen this behavior (0x42) a couple of times, usually the first time after registering the module, the GPRS states somethinh like '+ATCHIPSHUT' and then 0x42

In net.h I find
#define NET_STATE_NETINITCP 0x42 // Short pause during GPRS TCP reconnect

I assume the 0x42 occurs if the GPRS-attach is unsuccessful and the module goes for a retry.

When powering up the module I usually get the following led sequnce:

Green led 9x - 9x - 9x -> red+green led 1 long -> green led 6x - 5x - 2x- 1x

With one of my early Think City-fw builds (on 2.5.1) the module always initialized with green led 6x - 6x - 6x - 4x -1x (no red led)

All is OK if the green flashes 1x only (then GSM and GPRS is OK).

Can you try your Tele2-SIM in a phone or a computer, to verify you can make GPRS-attach?

Are you sure Tele2 has the sufficient coverage at the location you are testing? (make sure the antenna connector is applied correct)

/Håkon

2013/9/3 Nikolay Shishkov <nshishkov@yahoo.com>

While waiting for the GeoSIM guys to figure out the SMS problem in Sweden, I am testing the OVMS with a long forgotten card with a Swedish operator Tele2, that I managed to get to work... or sort of.

The initialization seems to go ok - the OVMS gets to the point of 1 green blink, and then after 2 such normal blinks, pulls lots of red blinks and goes back to 3 (or 4) green blinks - I have hard time counting them that fast.

I have configured the gprs correctly with internet.tele2.se as an apn, no username, no password. When I send "GPRS?" sms, I get in response the apn name and the other parameters, and the status is "not connected" with (0x42).

What does 0x42 mean, and is there anything else I could try?

_______________________________________________
OvmsDev mailing list
OvmsDev@lists.teslaclub.hk
http://lists.teslaclub.hk/mailman/listinfo/ovmsdev