Fetching…
Your module is running an outdated partitioning scheme.
We recommend upgrading your partitioning scheme to support firmware updates larger than 4MB in size.
The upgrade procedure runs fully automatic, you just need to start it. Depending on your configuration, the upgrade can take up to 10 minutes to finish, so please be patient.
In case something goes wrong, the module will reboot into standard mode, and you can use this page to display and download the upgrade log for further analysis.
Note: in case something goes badly wrong, you may need to reinstall the module via USB. See user guide on how to do this.
We strongly recommend creating a config backup first in case you haven't done already: Configuration Backup
The upgrade process has failed to finish the store migration, most likely caused by a config filesystem corruption. Please check the upgrade log for details.
We recommend doing a factory reset (erasing & reformatting the config store) now to get a clean state. The upgrade procedure will continue automatically after the reboot.
Note: after the factory reset, the module will reboot into the initial setup mode (with Wifi
network OVMS). You can then restore your config backup if available, or reconfigure
the module from scratch.
The partition upgrade process has finished successfully:
The partitioning scheme is up to date.
The partitioning scheme cannot be determined or is not supported.
Please verify your firmware is up to date.
The partition upgrade has logged 0 error(s) and 0 warning(s).
The upgrade is running now, estimated run time: up to ? minutes
Keep this page open until the process has finished.
After the upgrade has finished, the browser will automatically reconnect to the module. You will need to login, the page will then automatically reload so you can check the upgrade result and log.
Important: due to the factory reset, the module will boot into the initial
setup mode. Open your Wifi network monitor now, and connect to the OVMS Wifi
network as soon as available, using the setup password OVMSinit.
Do not power off the module while the upgrade is running!
The expected upgrade time has passed.
Give the module another minute or two, then unplug & replug the module.
If the module still doesn't come back online
(with the initial OVMS
Wifi network) you will need to
reflash the module via USB.
Sorry for the inconvenience!