<div dir="auto">Hi,<div dir="auto">Has anyone had any problems with CAN bus logging? </div><div dir="auto"><br></div><div dir="auto">I have a 32GB SD card installed and "SD status" gives:</div><div dir="auto"><br></div><div dir="auto"><i><b>SD CARD is inserted</b></i></div><div dir="auto"><i><b>Status: available</b></i></div><div dir="auto"><i><b>Name: SD32G</b></i></div><div dir="auto"><i><b>Size:  30419 MB</b></i></div><div dir="auto"><i><b>Free:  29767 MB</b></i></div><div dir="auto"><i><b><br></b></i></div><div dir="auto"><i><b>Card type: SDHC/SDXC</b></i></div><div dir="auto"><i><b>Max speed: 25000 kHz</b></i></div><div dir="auto"><i><b>Capacity: 30436 MB</b></i></div><div dir="auto"><i><b>CSD: ver=1; sector_size=512; capacity=62333952 read_bl_len=9</b></i></div><div dir="auto"><i><b>SCR: sd_spec=2; bus_width=5</b></i></div><div dir="auto"><br></div><div dir="auto">I have setup CAN1 and 2 to "listen" and started the logging like it's mentioned in the user guide, checked the status, I stopped it some time later, and when I go to open it from the Web UI it is empty, also tried from the Editor and it is also empty, removing the card is a bit tricky since the hardware is pretty tucked away in the console. I searched the manual for a format command but can't find anything.</div><div dir="auto"><br></div><div dir="auto">I do get messages and readings on the OVMS Android app, so at least the OBD CAN is fine.</div><div dir="auto"><br></div><div dir="auto">Oscar</div></div>