<div dir="ltr">Hi all, <div><br><div>I've been using Realterm to look at the 7000G's capabilities, and although the documentation only makes indirect reference to supporting uart multiplex mode, it does accept the AT+CMUX=0 command and reports back configuration values when queried with AT+CMUX? Unfortunately that appears to be where its support ends, the device responds with OK to the CMUX command however there is no response to the SABM command to open the control channel. I am sending the following hex in Realterm $F9 $03 $3F $01 $1C $F9.</div><div><br></div></div><div>Is there anything else worth trying? or that I'm missing in setting up the CMUX?</div><div><br></div><div>Cheers</div><div>Derek</div></div>