<html>
<head>
<meta content="text/html; charset=ISO-8859-1"
http-equiv="Content-Type">
</head>
<body bgcolor="#FFFFFF" text="#000000">
Hi Mark, <br>
<br>
Havent found any bugs yet.. Looking good so far.<br>
It was a bit weird not to get a SMS after the charge finished, but
then i realized this is how it's suppposed to be.<br>
<br>
One small thing, i received push messages , and the time displayed
is 24:53<br>
shoudn't this be 00:53? <br>
<br>
Tomorrow i will drive around a bit, and do some more testing<br>
<br>
-Michael<br>
<br>
<br>
<br>
<br>
Op 13-2-2012 2:57, OVMS Developers schreef:
<blockquote
cite="mid:5FC5AB11-4822-4B4D-9655-8C23D8081046@webb-johnson.net"
type="cite">
<div><br>
</div>
<div>Dear Developers,</div>
<div><br>
</div>
<div>We finally have a feature complete release candidate for the
OVMS software. At this stage, we would like to get this deployed
to as many cars as possible to work out any final bugs.</div>
<div><br>
</div>
<div>This release candidate is version 1.2.0-rc3, and you can find
it on github in the master branch.</div>
<div><br>
</div>
<div>To upgrade your car to this version, just flash the firmware
as normal (remember to set the flags to preserve EEPROM or
you'll have to reset the parameters - the experimental config
has these flags set correctly for upgrades).</div>
<div><br>
</div>
<div>There are two changes that might impact you:</div>
<div><br>
</div>
<div>
<ol class="MailOutline">
<li>This version has support for the GSM-only/GPRS-enable
switch on the PIC board, so please take care with this. You
will need the switch OFF in order to get GPRS connectivity.
If you see the usual red-green alternating LED sequence then
a solid green without any red light blinking, the switch is
probably in the wrong position (you should try it in the
other position, then reset the module).<br>
<br>
</li>
<li>This version re-works the old compile-time #define
statements to be run-time FEATURE settings. The only one
important is the WRITE enabled can bus, which is feature
#15. To enable this feature, send a SMS to the car (from
your registered phone) "FEATURE 15 1", and then reboot the
module.</li>
</ol>
</div>
<div><br>
</div>
<div>Compared to the v1.0 firmware, there are a huge number of
enhancements in v1.2. The biggest of these are:</div>
<div><br>
</div>
<div>
<ul class="MailOutline">
<li>FEATURES (write-enabled CAN bus, location streaming,
minimum SOC alerts, etc).<br>
</li>
<li>Optional digital speedometer experimental code</li>
<li>Improvements in miles->km conversions</li>
<li>Improvements in modem initialisation and control</li>
<li>Fixes for support of sub-zero temperatures and battery
pre-heating before charging</li>
<li>Watchdog timer support</li>
<li>App->Server->Car command support, including:</li>
<ul>
<li>Start/Stop Charge</li>
<li>Set charge mode</li>
<li>Set charge current</li>
<li>Activate/Deactivate Valet Mode</li>
<li>Lock/Unlock Car (doors only - alarm and immobiliser
cannot be deactivated where fitted [non-US cars])</li>
<li>Feature list and set</li>
<li>Parameter list and set</li>
<li>Wake up car</li>
<li>GPRS utilisation</li>
</ul>
<li>Social group subscription</li>
<li>Ambient temperature monitoring</li>
<li>Many more vehicle parameters sent to server (including
speed, direction, altitude, charge states, doors, etc)</li>
</ul>
</div>
<div><br>
</div>
<div>The Android App (in the market) already has experimental
support for most of these new features, and the iPhone App is
currently being extended (and we should have an experimental
testflight release this week).</div>
<div><br>
</div>
<div>We will most likely have a few more release candidate
releases before final end-user firmware is cut, but we would
like to get the current 1.2.0-rc3 installed in as many cars as
possible, in the next few days - and would be grateful if you
could assist.</div>
<div><br>
</div>
<div>Any questions / problems should be addressed to this
developers mailing list.</div>
<div><br>
</div>
<div>Regards,</div>
<div>Mark.</div>
<div><br>
</div>
<br>
<fieldset class="mimeAttachmentHeader"></fieldset>
<br>
<pre wrap="">_______________________________________________
OvmsDev mailing list
<a class="moz-txt-link-abbreviated" href="mailto:OvmsDev@lists.teslaclub.hk">OvmsDev@lists.teslaclub.hk</a>
<a class="moz-txt-link-freetext" href="http://lists.teslaclub.hk/mailman/listinfo/ovmsdev">http://lists.teslaclub.hk/mailman/listinfo/ovmsdev</a>
</pre>
</blockquote>
<br>
<br>
<pre class="moz-signature" cols="72">--
Stegen Electronics
Kwartslaan 95
3162 RD Rhoon
The Netherlands
Tel: +31 10-5016960
Skype: stegen.com
<a class="moz-txt-link-abbreviated" href="http://www.stegen.com">www.stegen.com</a></pre>
</body>
</html>